Stainless Steel Plugs, Caps, End Caps
Plugs and end caps made of stainless steel close off open tube ends neatly. Turned from solid material, flat, domed or half-round, with knurl or lamella, also with M8 thread or through hole.
























Closing tube ends with plugs: shapes, hold, installation
An open tube end looks unfinished, collects dust and has a sharp edge. A plug is driven into the tube and closes it permanently. Our plugs are turned from solid material, and the surface is finely turned.
Head shapes
- flat: flush, calm finish, very modern
- domed: slightly rounded, pleasant on handrails and in passageways
- half-round: clearly domed, emphasises the tube end and is particularly pleasant to grip
Knurl or lamella
The shank holds the plug in the tube. A knurl (fine fluting) presses into the inner wall of the tube when driven in. A lamella is spring-loaded and holds by clamping force. Both hold without adhesive; for handrails outdoors, a drop of adhesive can provide additional sealing.
Special versions
- M8 thread: for screwing on a ball, a hook or a threaded rod
- Through hole 12 or 12.2 mm: for rods, ropes or cables that are routed through the tube end
Fit
Plugs are matched to the outside diameter and wall thickness, for example 33.7 × 2 mm. There are separate plugs for tubes of 16 × 1 mm. Check the wall thickness of existing tubes: a plug for a 2 mm wall sits too loosely in a tube with a 1.5 mm wall.
Driving in without scratches
Position the plug straight, place a piece of wood or a folded cloth on top and drive it in with a rubber mallet. A steel hammer directly on the stainless steel leaves marks. For tubes that you have cut to length yourself, deburr the inner edge beforehand.
