
Stainless steel plug 48.3 x 2 half-round knurled solid material
- Made in Germany since 2009
- Fast shipping
Description
Stainless steel plug, 1 piece
- Suitable for stainless steel tube 48.3 × 2 mm
- With knurling
- Version: half-round
- Solid material, very sturdy
- Surface: finely turned
- Fitting: driven onto the tube
- Manufacture: in Germany
Stainless steel plugs: features and use
A plug closes an open tube end cleanly and permanently. It takes the sharpness off the cut edge, keeps dust and water out of the tube and gives handrails, clothes rails and balustrades a finished end. Our plugs are turned from solid material and are driven into the tube.
Head shape
- flat: flush, calm finish with a clean edge
- domed: slightly rounded, pleasant on handrails and in passageways
- half-round: clearly domed, emphasises the tube end and sits well in the hand
Hold in the tube
A knurled shaft presses into the inner wall of the tube as it is driven in, while a lamella springs and holds by clamping force. Both hold without adhesive. Outdoors, a drop of epoxy adhesive adds extra sealing.
Special versions
- with M8 thread: for screwing on a ball, a hook or a threaded rod
- with through hole: for rods, ropes or cables that are routed through the tube end
Typical applications
- Ends of handrails and balustrade rails
- Clothes rails projecting beyond the brackets
- Posts, fence tubes and frames made of round tube
- Furniture and shopfitting with stainless steel tube
Driving in without scratches
Deburr the inside of the tube edge, position the plug straight, place a piece of wood or a folded cloth on top and drive it in with a rubber mallet. A steel hammer used directly on the stainless steel leaves marks.
Fit
This plug fits stainless steel tube 48.3 x 2 mm. It sits in the inside diameter of 44.3 mm (outside diameter minus twice the wall thickness). When working with existing tubes, check the wall thickness: in a tube with a thinner wall the plug will fit too loosely.
All versions
| Version | Article number |
|---|---|
| flat, knurled | S192 |
| domed, knurled | S193 |
| domed, knurled, through hole Ø 12.2 mm | S194 |
| domed, knurled, M8 thread | S195 |
| half-round, knurled (this page) | S196 |
Plugs are also available for the tubes 16 x 1 mm, 21.3 x 2 mm, 26.9 x 2 mm, 33.7 x 2 mm, 42.4 x 2 mm, 60.3 x 2 mm; all under Plugs and end caps.
Product and safety information Steel Deal
Manufacturer: Steel-Deal UG (haftungsbeschränkt)Country of origin: Germany
Email: info@steel-deal.de