
Stainless steel plug 33.7 x 2 mm flat lamella solid material
- Made in Germany since 2009
- Fast shipping
Description
Stainless steel plug, 1 piece
- Suitable for stainless steel tube 33.7 × 2 mm
- With lamella
- Design: flat
- Solid material, very sturdy
- Surface: finely turned
- Installation: knock onto the tube
- Manufacture: in Germany
Stainless steel plugs: features and use
A plug closes an open tube end permanently and neatly. It takes the sharpness off the cut edge, keeps dust and water out of the tube and gives handrails, clothes rails and balustrades a finished end. Our plugs are turned from solid material and are knocked into the tube.
Head shape
- flat: flush, calm finish with a clean edge
- domed: slightly rounded, pleasant on handrails and in passageways
- half-round: clearly domed, emphasises the tube end and sits well in the hand
Hold in the tube
A knurling on the shaft presses into the inner wall of the tube when the plug is knocked in, while a lamella springs and holds by clamping force. Both hold without adhesive. Outdoors, a drop of epoxy adhesive additionally seals the joint.
Special versions
- with M8 thread: for screwing on a ball, a hook or a threaded rod
- with through hole: for rods, ropes or cables that are routed through the tube end
Typical applications
- Ends of handrails and balustrade rails
- Clothes rails projecting beyond the brackets
- Posts, fence tubes and frames made of round tube
- Furniture and shopfitting with stainless steel tube
Knocking in without scratches
Deburr the inside of the tube edge, position the plug straight, place a piece of wood or a folded cloth on top and knock it in with a rubber mallet. A steel hammer used directly on the stainless steel leaves marks.
Fit
This plug fits stainless steel tube 33.7 x 2 mm. It sits in the inside diameter of 29.7 mm (outside diameter minus twice the wall thickness). Check the wall thickness of existing tubes: in a tube with a thinner wall, the plug sits too loosely.
All versions
| Version | Article number |
|---|---|
| flat, lamella (this page) | S170 |
| domed, knurled | S173 |
| domed, knurled, through hole Ø 12 mm | S174 |
| domed, knurled, M8 thread | S175 |
| half-round, knurled | S176 |
Plugs are also available for the tubes 16 x 1 mm, 21.3 x 2 mm, 26.9 x 2 mm, 42.4 x 2 mm, 48.3 x 2 mm, 60.3 x 2 mm; all under Plugs and end caps.
Product and safety information Steel Deal
Manufacturer: Steel-Deal UG (haftungsbeschränkt)Country of origin: Germany
Email: info@steel-deal.de