
- Made in Germany since 2009
- Fast shipping
Description
Tube is pushed through and fixed with a lateral grub screw. The cover rosette is not needed; the flange has a very attractive shape.
- Material: AISI 316 V4A
- Surface: grit 240 ground
- 3 holes of 8.5 mm, countersunk
Matching screws and tubes can be found in our shop.
Stainless steel flange: properties and use
The flange connects a tube to a wall, floor or ceiling. The tube is pushed through and fixed with a lateral grub screw. The flange is shaped so that it looks good without a cover rosette; the holes are countersunk so that countersunk head screws finish flush.
Typical applications
- Base and wall points for handrails and balustrade posts
- Clothes rails between two walls
- Supports, frames and room dividers made of round tube
- Shopfitting, counters and footrests
Round or oval
The round flange absorbs load evenly from all directions. The oval form with four holes has the holes further apart and thus more leverage against tilting in one direction; it suits narrow surfaces such as stair strings or wall tops.
Mounting
Choose stainless steel countersunk head screws to match the hole. In concrete and solid brick, expansion anchors hold; in perforated brick and aerated concrete, long-shaft plugs or injection anchors. Tighten the grub screw only once the tube is aligned. Outdoors, place the flange on a level, slightly raised surface so that no water stands underneath.
All versions
| for tube | Article number |
|---|---|
| 21.3 mm | P70213 |
| 26.9 mm | P70269 |
| 33.7 mm | P070400 |
| 42.4 mm | P070500 |
| 42.4 mm oval | P07550 |
| 48.3 mm | P070600 |
| 48.3 mm oval | P075600 |
| 60.3 mm (this page) | P70603 |
Product and safety information Steel Deal
Manufacturer: Steel-Deal UG (haftungsbeschränkt)Country of origin: Germany
E-mail: info@steel-deal.de
Frequently asked questions
Welche Dübel benötige ich für die Montage?
Passende Nylon-Spreizdübel (Ø 6 bis 12 mm) sind separat in unserem Shop erhältlich. Geeignet für Beton, Mauerwerk und Lochziegel. Tipp: Bohrlochtiefe = Dübellänge + Dübeldurchmesser.