Accessories & Stainless Steel Small Parts

All items: Accessories & Stainless Steel Small Parts (73)


Stainless steel small parts for clothes rails, handrails and balustrades: wall and floor flanges, cover rosettes, plugs and end caps, balls, push-fit fittings, post holders, S-hooks and care products. Matched to the standardised tube diameters.

Choosing the right stainless steel small parts

Whether you are extending a clothes rail, building a handrail or repairing a balustrade, what matters is that small parts fit the tube exactly. Three details are enough: outside diameter, wall thickness and material.

The standardised tube diameters

Stainless steel tubes for balustrades, handrails and clothes rails follow the dimensions of the tube standards. The outside diameter is derived from the nominal size (DN), which is stated in inches:

Outside diameterNominal sizeInchesTypical use
21.3 mmDN 151/2"slim clothes rails, infill bars
26.9 mmDN 203/4"clothes rails, cross bars
33.7 mmDN 251"clothes rails, wall handrails
42.4 mmDN 321 1/4"handrails, balustrade rails, posts
48.3 mmDN 401 1/2"balustrade posts, rails
60.3 mmDN 502"heavy-duty posts, supports

The wall thickness of our tubes is generally 2 mm. Plugs and push-fit fittings sit inside the tube and must therefore match the inside diameter: outside diameter minus twice the wall thickness, so 29.7 mm for 33.7 × 2 mm. When working with existing tubes, always measure both: the outside with a vernier calliper and the wall at the open end of the tube.

The product areas at a glance

Materials

Our small parts are predominantly made of V2A (1.4301, AISI 304), which is durable indoors and in normal outdoor conditions. Turned parts are often made from 1.4305, a V2A with added sulphur that machines better. Close to the coast, at swimming pools or in contact with road salt, V4A (1.4404) is the more resistant choice. Do not combine stainless steel with galvanised or black steel screws: where they make contact, corrosion occurs in the presence of moisture. Always use stainless steel screws.

Choosing matching finishes

Most of our parts are ground to grit 240, matching ground tubes. Hollow balls have a finer satin finish (grit 400 to 600), plugs are finely turned and S-hooks are polished. If you combine parts from different manufacturers, match the finish with an abrasive fleece worked in the direction of the grain.