Yacht Accessories & Equipment

























Here you will find equipment for deck, cockpit, engine and navigation: ventilation plates, filler necks and drain plugs made of stainless steel, holders for fenders, fishing rods and flagpoles, sacrificial anodes and impellers, compasses from Autonautic, lines from Seilfabrik Ullmann, bilge pumps of the Rule series from Xylem, as well as bimini tops and telescopic supports for covers.
Choosing equipment for boat and yacht
The subcategories at a glance
- Equipment: ventilation and gill plates, filler necks, tank vents, drain plugs, ladders, boat hooks, fender holders, flagpoles, aerial holders, trailer rollers, steering wheels from Riviera and safety lines from Wichard and Kong.
- Hooks & Holders: holders for outboards, fishing rods, drinks, bottles, table tops, lifebuoys and flagpoles, plus fender baskets, spiral hooks and quick-release fender hooks from Fastfender.
- Rail fittings: fender hooks with snap lock, pop-out fender hooks, fender eyes and buoy hooks made of A4 stainless steel.
- Electrics: cable deck glands and swan necks for cables through the deck, as well as automatic and flat bilge pumps of the Rule series.
- Rope & Lines: braided lines, mooring lines, halyards, sheets, bungee cords and mooring warps with snubber from Seilfabrik Ullmann.
- Engine & Drive: sacrificial anodes for Volvo Penta drives and shafts, impellers for cooling water pumps, flushing attachments, trim tabs and engine mounts.
- Compasses & Navigation: surface-mount, flush-mount, bulkhead and roof compasses from Autonautic, protective covers and wind direction indicators for small dinghies.
- Bimini & Canvas Covers: three-arm bimini tops, PVC connectors for the frame, bimini holders for inflatable boats and telescopic supports for covers.
Material: A4 or A2
The stainless steel items are mostly made of A4 (1.4401, AISI 316), some of A2 (1.4301, AISI 304). The screw standard ISO 3506-1 describes A4 as alloyed with molybdenum and markedly more corrosion resistant than A2; according to this standard, A2 is not suitable for environments containing chloride, such as at sea. A2 is resistant indoors, in the weather and in fresh water, but in salt water and chloride-laden air it can show surface rust and pitting corrosion. For deck and rail, therefore, choose A4. According to the standard, A4 can be used in some environments containing chloride, but not in many marine environments. Rinse stainless steel with fresh water after trips in salt water. The differences are explained in the guide V2A, V4A or Duplex on a boat.
Avoiding contact corrosion
When a noble and a less noble metal meet in the presence of moisture, a corrosion current flows and the less noble metal is corroded more rapidly. In a damp environment, therefore, do not connect stainless steel to galvanised steel or aluminium, and choose screws that are at least as noble as the component, that is, A4 screws on A4 fittings. How to clean fittings is explained in the guide Caring for stainless steel on board.







