Self-service blister packs, stainless steel A4
Screws, nuts and washers made of A4 stainless steel in self-service blister packs: slotted, cross-head, hexagon socket and hexalobular socket screws to DIN and ISO, wood screws and sheet metal screws, hexagon nuts, dome nuts, wing nuts and self-locking nuts, washers, spring washers, split pins and ring split pins, plus countersunk wood screws made of bronze and blind rivets made of Monel.
























Standards, materials and dimensions at a glance
A4 in self-service blister packs: selection and limits of use
Why A4
A4 is alloyed with molybdenum and is considerably more corrosion resistant than A2. According to ISO 3506, A4 can be used in some environments containing chloride, but not in swimming pools with chloride as a cleaning agent and not in many marine environments. A1 to A3 are not intended for chloride. How to keep stainless steel bright on board is described in Caring for stainless steel on board. The successor standards of the most important DIN standards are shown in the table under Self-service blister packs, stainless steel A2.
Hexalobular socket and hexagon socket
In addition to screws with slot and cross recess, this range includes countersunk screws with hexalobular socket to ISO 14581, sheet metal screws with hexalobular socket to ISO 14585, ISO 14586 and ISO 14587, and countersunk screws with hexagon socket to ISO 10642. Because of their head geometry, countersunk screws to ISO 10642 cannot take full load; as a guide value, 80 per cent of the tightening torque and preload of a fully loadable screw of the same size applies.
Bronze and Monel
The countersunk wood screws to DIN 97 are also available in bronze. The blind rivets are made of Monel, a nickel-copper alloy whose corrosion properties are better than those of stainless steel. For the question of galvanic corrosion, the material of the rivet sleeve is what counts with blind rivets. Set blind rivets at least two rivet diameters from the edge. DIN 7337 for blind rivets has been withdrawn and replaced by the standards ISO 15973 to ISO 16585.
Galvanic corrosion and locking
If noble and less noble metals meet in a damp environment, the less noble one is eroded at a faster rate. The fastener should be of equal or higher nobility than the component. If an unfavourable pairing cannot be avoided, insulate the metals with spacers or coatings. The spring washers in A4 do not have spring-hard properties and cannot compensate for settlement losses through spring action. If screw and nut are both made of stainless steel, a lubricant on the thread prevents galling.
