Tubes, Rubbing Strips & Guardrail Fittings

























This category covers fittings for guardrails, tubular frameworks and hulls: guardrail bases, guardrail supports, T-pieces and corner connectors, handrails and handrail holders, stainless steel tube with end caps and canopy fittings, eye plates and folding eyes, rub rails, flagstaff holders and antenna bases. Most items are made of stainless steel A4, a few of A2 or duplex.
Guardrails, tubular frameworks and hull protection in stainless steel
The subcategories at a glance
- Deck and mast plates: eye plates, folding eyes, hook plates and U-bolts as fixed anchor points on deck and mast.
- Handles and handrails: handrails, handrail holders, pass-throughs and end pieces, also for the handrail on the sprayhood.
- Hooks and holders: flagstaff holders for the stern and hatch spring holders.
- Guardrail fittings: guardrail bases, supports, connectors, fairlead eyes, fender eyes and strap fittings.
- Tubes and fittings: stainless steel tube in lengths or by the metre, end caps, centre pieces, bimini and canopy fittings.
- Rub rails: flat and half-round strips as well as Kratzerstop against scratches and knocks on the hull.
- Accessories: antenna bases, battery retaining strap, recessed eye catch and bow pockets.
Clarify tube size and material first
Tube fittings are built for a specific tube diameter, often 22 or 25 mm. The matching size is stated for each version. Measure the outside diameter of the existing tube before you order connectors, bases or end caps.
As regards material: stainless steel A2 (1.4301) is resistant indoors, in the open air and in fresh water, but in salt water and salty air it can show surface rust and pitting corrosion. A4 (1.4401) is alloyed with molybdenum and is considerably more resistant, but is likewise not suitable for every marine environment. Which material suits which application is explained in the article V2A, V4A or duplex on the boat.
Fitting on deck
Apply sealant under the fitting and the screw heads, and tighten at the nut, not at the screw head, so that the sealant is not twisted out. Where stainless steel meets aluminium, for example on the mast, contact corrosion threatens the less noble metal in a damp environment. Separation at the contact point, for example with plastic or rubber, and screws made of a suitable material prevent this. Notes on bases and connectors can be found under Guardrail fittings.






