Swivels & Swivel Shackles
Swivels and swivel shackles in stainless steel A4, some in A2: eye-eye, eye-jaw and jaw-jaw, with hex socket, locknut or TX20 pin with locking pin, in a flat version and as anchor swivels. Also swivel shackles from Wichard in forged HR stainless steel. Swivels take the twist out of line and chain.














Choosing and using swivels correctly
What a swivel is for
A swivel connects two parts so that they can rotate and prevents line or chain from twisting. A swivel shackle combines a shackle with a rotating swivel: the jaw is therefore a shackle end with a pin. Jaw-jaw swivels have this shackle end on both sides, eye-jaw swivels on one side only, eye-eye swivels on neither.
At the anchor
At the anchor, a swivel shackle allows the anchor to rotate about its longitudinal axis. For the anchor at the bow roller, there are anchor chain swivels with a joint under Anchors and swivels. Much damage to ground tackle is due to material fatigue, for example on anchor swivels; therefore check swivels, shackles and chain regularly and replace them from time to time. Compare the breaking load of the swivel, which is given for each version, with that of the chain; the guide Connecting anchor chain with shackle and swivel shows what to look out for.
Securing the pin
On the jaws, the pin is closed with a hex socket, with a locknut or, with the Secur system, with a TX20 drive and locking pin; the Wichard swivel shackles have self-locking pins, hex socket pins or push-in pins. An ordinary threaded pin can work loose through vibration or varying load; secure it through the eye at the end of the pin, for example with wire.
No HR swivels underwater
The Wichard swivel shackles are made of forged, high-strength HR stainless steel 1.4542. According to Wichard, HR stainless steel is a martensitic, magnetisable steel (17.4 PH, 1.4542) and not A4. Wichard points out that HR parts can corrode if they are permanently immersed in a highly corrosive environment. Wichard does not recommend HR swivels for use underwater. For a swivel that stays permanently in the water, for example at the anchor, do not choose a version marked HR. After exposure to salt water, rinse swivels with fresh water; further advice is given in the guide Caring for stainless steel on the boat.
