Pins, split pins & stud screws
This category contains clevis pins, folding-nose pins and double ball locking pins, split pins to DIN 94, ring cotter pins, folding cotter pins, R-clips, Fokker pins, retaining rings and safety lanyards, plus lock nuts for rigging screws and stud screws with right-hand or left-hand thread. They connect forks and eyes on tensioners, terminals and fittings and secure the connection against slipping out.























Choosing pins and locking devices correctly
Pins: insert, secure, pull
Clevis pins connect forks, eyes and fittings; they are secured with a split pin or ring cotter pin through the cross hole. Folding-nose pins have a movable tab at the end: set crosswise, it secures the pin, set lengthwise, the pin can be pulled. With the folding-nose pins from Seasure, a built-in spring holds the tab in position. Ball-lock pins are held by a spring-loaded ball and can be inserted and pulled without tools. Safety lanyards keep pins captive on the fitting.
Pay attention to the material: the clevis pins with manual ball lock are made of A1, individual pins, rings and safety lanyards of A2, one series of folding-nose pins of A5, and most other items of A4. A1 is designed for machining and, because of its high sulphur content, is less corrosion resistant than A2. A1 and A2 are not intended for chloride environments such as swimming pools or marine environments. A5 is a stabilised steel with the properties of A4. According to ISO 3506, A4 can be used in some environments containing chloride, but not in swimming pools with chloride as a cleaning agent and not in many marine environments. More on this under V2A, V4A or duplex on the boat.
Split pin, ring cotter pin and R-clip
The nominal size of a split pin to DIN 94, now ISO 1234, corresponds to the diameter of the split pin hole. The split pin must fit into the hole without force; never use a split pin that is too thin, while one that is too long can be shortened. After insertion, the open end is bent over. R-clips based on DIN 11024 are also chosen according to the hole diameter; the matching hole is stated for every version. Ring cotter pins are wound spring rings that you turn through the cross hole of the clevis pin. Fokker pins are long locking pins with a ring for eyes and shackle pins.
Stud screws and lock nuts
Stud screws have a wood thread on one side and a metric thread on the other, and serve as an anchor point for wire rope tensioners on wooden posts and beams; the left-hand thread version is the counterpart to the right-hand thread version. In very hard wood, with a small edge distance and in narrow pieces of timber, pre-drill. Lock nuts with right-hand or left-hand thread secure the threaded parts of a rigging screw against turning after tensioning. You will find the matching tensioners under Turnbuckles & rigging screws, and fork and eye terminals under Terminals.
