
Stainless Steel Clothes Hook, Coat Hook with Pin, Made to Measure
- Made in Germany since 2009
- Fast shipping
Description
Stainless steel coat hook / clothes hook with pin, made to measure in Germany. The pin at the end of the hook stops the clothes hangers from slipping off.
Length A: 10 to 50 cm, freely selectable (selection above). Stainless and also suitable for outdoor use.
Features
- Material: V2A stainless steel, ground
- Pin: 8 mm thick, 1 cm long, prevents the clothes hangers from falling off
- Tube end: flat or domed, your choice
- Individual and easy to fit
Included in delivery
- 1 × tube 33.7×2 mm, V2A ground, made to measure with pin
- 1 × stainless steel round plate 70×4 mm incl. 4 holes of 6.5 mm each
- 1 × cover rosette 76 mm, ground to grit 240
- Screws and wall plugs
The mounting plate (round plate) is welded to the tube, making it particularly sturdy. Fitting: 4 drill holes, drive in the screws, done.
Important: After fitting, the cover rosette must be fixed in place with a little silicone or a hot glue gun.
Coat hook with pin: features and use
A coat hook made of 33.7 mm stainless steel tube that projects at a right angle from the wall. A pin 8 mm thick at the end of the tube is the most discreet hanger stop in the range.
How many hangers fit on it
Allow about 5 to 8 cm per clothes hanger with a jacket, and up to 10 cm for winter coats. A hook 30 cm long therefore holds three to six jackets. The 33.7 mm hook suits standard hangers whose hook opens to around 35 mm on the inside.
Typical applications
- Cloakroom in narrow hallways where there is not enough width for a rail
- Guest cloakroom next to the front door
- Dressing room and bedroom for the next day's clothes
- Hotel, surgery and office
Fitting
Bear the leverage in mind: the longer the hook, the greater the force on the upper screws. Long hooks belong in concrete or solid brick; in plasterboard, screw into the studs of the substructure. A cover rosette, where included with the item, is fixed in place after fitting with a little silicone or hot glue. For jackets, fit the hook at a height of about 160 to 180 cm, with several side by side at a spacing of 15 to 25 cm.
All versions
| Version | Article number |
|---|---|
| Stainless steel with solid ball 20 mm | KB85 |
| Stainless steel with cap | KB85KAP |
| Maple with cap | KB85KAP-Ahorn |
| Beech with cap | KB85KAP-Buche |
| Oak with cap | KB85KAP-Eiche |
| Ash with cap | KB85KAP-Esche |
| Spruce with cap | KB85KAP-Fichte |
| Kambala with cap | KB85KAP-Kambala |
| Pine with cap | KB85KAP-Kiefer |
| Cherry with cap | KB85KAP-Kirsche |
| Walnut with cap | KB85KAP-Nussbaum |
| Stainless steel with pin (this page) | KB85Pin |
Product and safety information Steel Deal
Manufacturer: Steel-Deal UG (haftungsbeschränkt)Country of origin: Germany
Email: info@steel-deal.de