Cleats & Bollards
Cleats made of A4 stainless steel for making fast mooring lines and ropes: flat, arched or with a hump, with holes, internal or external thread, folding and recessed, as lip cleat, fairlead, flag cleat, fender cleat and emergency cleat. Also bollards, cross bollards and horn bollards, a wire rope cleat and plastic cleats.
























Choosing and fitting cleats and bollards
The right size
Manufacturers recommend just under one inch of cleat length for every sixteenth of an inch of line diameter: a line of around 10 mm suits a cleat of about 15 cm, and one of around 13 mm suits a cleat of about 20 cm. Larger cleats and cleats with smooth, rounded horns are kinder to the line, since sharp edges and tight bends weaken it. Also look for large, sturdy bases with enough material around the holes. If in doubt, choose the largest cleat that the deck has room for.
Fitting on deck
- Below deck, a backing plate of twice the cleat length and half the cleat length in width is required; on deck, a base plate that is about a quarter longer and wider than the cleat.
- Fasten with stainless steel bolts rather than screws and place stainless steel washers under the nuts.
- Where possible, do not fit cleats on decks with a soft core, such as balsa. If this cannot be avoided, the core must be removed beforehand and the area reinforced; leave this work to a specialist workshop where possible.
- Place fairleads and lip cleats as close to the cleat as possible and avoid changes of direction of the line on the way there.
With the cleats with aluminium backing plate, stainless steel meets aluminium. Complete electrical insulation with insulating sleeves, insulating washers and insulating paste, with no gap between the insulation and the surface, can prevent contact corrosion; on board, however, a seamless separation often cannot be achieved. Therefore also avoid gaps and hollows at the contact point in which water can collect.
Folding and recessed
For some of the recessed cleats, the manufacturer's specification mentions a design that prevents rattling and sits flush when stowed. The folding cleats with two holes or two screws have a plastic rattle stop.
You will find bolts, nuts and backing plates under Eye bolts, screws and nuts; for care, read the guide Caring for stainless steel on your boat.
