Cleats, Blocks & Bolts
























Fittings for making fast, redirecting and fastening on board: cleats, folding cleats and bollards, blocks, mini blocks and cam cleats with accessories, plus eye bolts, U-bolts, ring bolts and eye screws, eye nuts and nuts. Predominantly in stainless steel A4, the rope blocks in A2, some in Duplex or plastic, as well as fittings from Wichard, Allen and Spinlock.
Making fast, redirecting, fastening
The subcategories
- Cleats and bollards: cleats with holes or thread, folding and recessed, lip, fairlead, flag, fender and emergency cleats, as well as bollards and cross bollards for making fast mooring lines and ropes.
- Blocks and accessories: rope blocks and double blocks, mini blocks and blocks from Wichard that redirect lines and reduce friction, plus cam cleats, fairleads and swivel bases from Allen.
- Eye bolts, screws and nuts: eye bolts and U-bolts for mounting through the deck, ring bolts and eye screws, eye nuts, hooks with thread and nuts.
Mounting on deck
Heavily loaded fittings such as cleats need a reinforced base. Below deck, a backing plate twice the length of the cleat and half the length of the cleat in width is required. Fasten with bolts made of stainless steel rather than screws, and place washers made of stainless steel under the nuts so that the load is distributed. Where possible, do not mount cleats on decks with a soft core, such as balsa. If this cannot be avoided, the core must be removed beforehand and the area reinforced; leave this work to a specialist workshop wherever possible.
The load depends on the direction
The load on the block depends on the angle of deflection. Wichard states a load factor of 75% at 45°, 100% at 60°, 140% at 90°, 180% at 120° and 200% at 180° of the pull in the line: a pull of 100 kg on a line redirected through 180° results in 200 kg on the block. The fitting from which the block hangs must be able to take this load. For ring bolts to DIN 580, the stated load capacity applies only in the axial direction and only if the bolt is screwed in fully and sits flat; side pull should not be applied.
Material
Where stainless steel meets aluminium, for example with a backing plate made of aluminium, there is a risk of contact corrosion on the less noble metal. Complete electrical insulation with insulating sleeves, insulating washers and insulating paste, with no gap between the insulation and the surface, can prevent contact corrosion; on board, however, a seamless separation often cannot be achieved. You should therefore also avoid gaps and hollows at the point of contact in which water collects. More on choosing the material can be found in the guide V2A, V4A or Duplex on the boat.



