Wire ropes
Stainless steel wire ropes on the reel: stiff as 1x19, medium-flexible as 7x7, flexible as 7x19, plus 6x36 with steel core as well as 6x19 and 8x7 with fibre core, bare, with clear, white or coloured PVC coating and in duplex stainless steel. You will also find safety ropes, locking pins with safety rope and a guardrail wire replacement set here.

















Finding the right stainless steel rope
Construction and flexibility
The first number in the designation gives the strands, the second the wires per strand. 1x19 is a single strand of 19 wires: very stiff, for static use only, used on boats as shroud, stay and guardrail wire. Thanks to its high metallic cross-section it achieves high breaking loads. 7x7 consists of seven strands with seven wires each; in static use it can be bent if the bending radius is at least ten times the rope diameter. It is suitable for balustrade infills, suspensions and fences. 7x19 is very flexible thanks to its many fine wires and is intended for deflection, but is more sensitive and has a lower breaking load.
The 6x36 IWRC has a steel core and is designed for high loads and small bending radii; 6x19 and 8x7 have a polypropylene fibre core. Ropes with a steel core have a higher fill factor than ropes with a fibre core, and the calculated breaking force rises with the fill factor.
Reading the abbreviations
For stranded ropes such as 7x7 and 7x19, “sZ” stands for right-hand cross lay: the wires in the strands are laid to the left, the strands in the rope to the right. “1570 N/mm²” is the nominal tensile strength of the wires: the actual tensile strength of each wire must not fall below this value. For coated ropes, the specification 4/5 mm gives the rope diameter and the outer diameter.
Coated or bare
The PVC coating protects hands and surfaces; with the clear coating the stainless steel remains visible. For deflection, the specialist trade advises against PVC coating, because PVC does not withstand the friction and forces involved in deflection; a rope with PA coating is recommended there. For thimbles, clamps and terminals, check whether the size refers to the rope or to the outer diameter including the coating.
Cutting to length and material
We supply most ropes as a full reel, and the reel length is stated for each version; the transparent-coated 7x19 is available by the metre. Before cutting, wrap the cutting point with strong adhesive tape so that the ends do not fray; ropes that are not low-stress stranded should also be tied off firmly to the left and right of the cutting point; suitable cutters can be found under Tools for wire ropes. The ropes are available in A4, in some cases in A2, and in duplex stainless steel; the differences are explained in V2A, V4A or duplex on the boat.
