Stainless steel push-fit fittings
Push-fit fittings join stainless steel tubes without welding: insert the tube, bond it, done. For handrails, balustrades, frames and coat racks made from tubes of 33.7, 42.4 and 48.3 mm.


Joining tubes without welding
Welding stainless steel requires shielding gas, practice and extensive finishing of the weld seam. Push-fit fittings replace the weld seam with a precisely fitting joint: the fitting has spigots that engage in the inside diameter of the tubes. With a two-part adhesive, this produces a firm, permanent connection.
Fit
Push-fit fittings are designed for a specific tube size, usually outside diameter × 2 mm wall thickness. For 42.4 × 2 mm, the inside diameter is 38.4 mm. Tubes with a different wall thickness do not fit or sit loosely. Our corner connector with vertical outlet fits 33.7 × 2, 42.4 × 2 and 48.3 × 2 mm, material V2A, ground to grit 240.
Bonding in five steps
- Cut the tubes to length at a right angle and deburr them inside and outside.
- Lightly roughen the bonding surfaces with an abrasive fleece and degrease them with methylated spirits or acetone.
- Mix the rapid-setting epoxy adhesive and apply a thin layer to the spigot.
- Push on the tube, align it and hold it in place until the adhesive has set.
- Wipe off any escaping adhesive immediately while it is still soft. Do not load the joint until it has fully cured.
The epoxy adhesive bonds to metal, glass, stone, ceramic and wood and can also be used as a thread-locking compound.
Where push-fit fittings reach their limits
Bonded push-fit connections are ideally suited to handrails, frames and coat racks. Balustrades that protect against falls, however, are subject to the requirements of the state building regulations (Landesbauordnung); their dimensioning should be left to a specialist company. For coat racks without bonding, we offer our 25 series, whose parts are secured with grub screws.
