
Stainless steel corner connector push-fit fitting
11,90 EUR
incl. 19% VAT plus shipping
- Made in Germany since 2009
- Fast shipping
Description
Accessories
Description
Stainless steel corner connector, push-fit fitting with vertical outlet
- Suitable for tube 33.7 × 2 mm, 42.4 × 2 mm or 48.3 × 2 mm
- Material: V2A AISI 304
- Surface: ground, grit 240
- Very sturdy and high-quality workmanship
Push-fit fitting: joining tubes without welding
Push-fit fittings replace the weld seam with a precisely fitting connection. The fitting has spigots that engage in the inner diameter of the tubes; with two-component adhesive this produces a firm, permanent connection. This corner connector has a vertical outlet and therefore joins three tubes.
Fit
The fitting suits tubes with 2 mm wall thickness: 33.7 × 2 mm (inside 29.7 mm), 42.4 × 2 mm (inside 38.4 mm) or 48.3 × 2 mm (inside 44.3 mm). Tubes with a different wall thickness do not fit or sit loosely.
Bonding in five steps
- Cut the tubes to length at a right angle and deburr them inside and out.
- Roughen the bonding surfaces with abrasive fleece and degrease with methylated spirits or acetone.
- Mix the quick-setting epoxy adhesive and apply a thin layer to the spigot.
- Push on the tube, align it and hold it in place until the adhesive has taken hold.
- Wipe off any excess adhesive immediately; only apply load once fully cured.
Typical applications
- Corner points of handrails and frames
- Counter surrounds and footrests
- Clothes racks and shelves made of tube
Railings that protect against falls are subject to the state building regulations (Landesbauordnung); their dimensioning should be left to a specialist company.
Product and safety information Steel Deal
Manufacturer: Steel-Deal UG (haftungsbeschränkt)Country of origin: Germany
Email: info@steel-deal.de