Hooks & Holders

Hooks & Holders

Holders that keep equipment in place on the rail, deck and bulkhead: outboard motor brackets, fishing rod holders with gasket and inner insert for flush-mount rod holders, drink, bottle and table top holders, holders for lifebuoys and lifebuoy lights, flagpole and boat hook holders, fender baskets, Fastfender quick-release fender hooks, spiral hooks for sail ties, eye bolts, hatch fasteners, rowlock sockets and door stops.

Choosing the right hooks and holders on board

Measure the rail tube first

Many holders sit directly on the rail. Flagpole holders, drink holders and rod holders for rail mounting are made for specific tube diameters, which are given for each version. Measure the outer diameter of your rail tube before you order. For the flagpole holder, also choose the diameter of your flagpole; this too is given for each version. Other holders are mounted on the wall or on the deck, such as the bottle holder for wall mounting or the triple drink holder with welded-in screws for deck mounting.

Adjusting fenders quickly

The Fastfender hangs on the guardrail wire or the rail tube and holds the fender line in a built-in clamp. Fastfender describes the handling as follows: thread the line through the holder from below, pull it slightly to adjust until it comes out of the clamp, bring the fender to the right height and insert the line again. Secure the end of the line with a simple knot or a figure-of-eight knot. Choose the version to suit the rail diameter and the line thickness. The A4 fender baskets each hold two fenders; there are separate versions for port and for starboard.

Mind the load and the material

Outboard motor brackets have a maximum load, which is given for each version; compare it with the weight of your engine. The load capacity is also given for the folding table top holder. The lockable fishing rod holder is secured with a padlock. You will find stainless steel padlocks under Equipment; check before buying whether the lock fits the holder.

The outboard motor, lifebuoy, bottle and table top holders are made of A2. A2 is resistant indoors, in the weather and in fresh water; in salt water surface rust may appear, so rinse these holders with fresh water after trips in salt water. The guide V2A, V4A or duplex on the boat explains which stainless steel belongs where.