Compasses & Navigation
Autonautic magnetic compasses for motor boats and sailing boats, tenders and commercial shipping: surface-mount compasses with base or bracket, flush-mount compasses with a flat, conical or tactical compass card, bulkhead compasses for vertical installation, roof compasses with mirror, small compasses for deck mounting, protective covers and wind direction indicators for Optimists and small dinghies.













Choosing and fitting the right boat compass
Designs
- Surface-mount compass with base: for horizontal mounting on deck or on the dashboard, with built-in, adjustable compensators.
- Surface-mount compass with bracket: sits in a mounting bracket, with an 85 mm card.
- Flush-mount compass: set horizontally into a mounting hole, some versions with a wide flange.
- Bulkhead compass: for vertical installation in a bulkhead, with a conical card and front reading.
- Roof compass with mirror: Autonautic describes it as a solution for convenient reading from the helmsman's position when a reflection tube cannot be fitted; it is intended for commercial shipping.
- Small deck-mounting compass: according to Autonautic, intended for rigid inflatable boats and tenders; the card can be read from many angles, and no drilling is needed for mounting on a flat surface.
The diameter, shape and colour of the card and the illumination are given with each version. For several models, including the roof compass, Autonautic cites the standard ISO 25862:2019 and Directive 2014/90/EU on marine equipment.
Mounting location and deviation
For the flush-mount compasses of the C15/150 series, the drilling template specifies that the centreline of the compass be aligned parallel to the centre of the boat. Any magnetic interference can affect a compass. In the instructions for the roof compass, Autonautic therefore requires sufficient distance from the engine, wiper motor, fire extinguisher, other compasses and loudspeakers, a lubber line on the imaginary fore-and-aft centreline and exclusively non-magnetic screws made of stainless steel A4. The error that magnetic influences cause in the compass reading is called deviation; it is recorded in a deviation curve. For the roof compass, according to Autonautic, this curve must be checked every year and after every newly installed device. If the deviation of the roof compass is above 20°, Autonautic recommends relocating it or having it compensated by an authorised technician.
Care
For the roof compass, Autonautic prescribes cleaning it only with water and soap and never with solvents or abrasives. If a bubble appears, do not top up with any liquid; Autonautic recommends an overhaul every four years. Protective covers made of PVC are available in this category; which card size they fit is given with each version. You will find further wind indicators under Wind Vanes and Wind Indicators.
