Retaining rings, rivets and clamps made of stainless steel
Retaining rings and retaining washers, spring washers and spring cotters, blind rivets, round head rivets and rivet nuts, parallel keys, set collars and hose clamps made of stainless steel. Article number, material and packaging unit are given for each version.
















Standards, materials and dimensions at a glance
Securing, riveting, clamping
This category brings together standard parts that hold components on shafts, join sheets, transmit torque or secure hoses. The overview above this text shows which standards, materials and dimensions are in the range.
Retaining rings DIN 471 and DIN 472, retaining washers DIN 6799
Retaining rings hold components such as rolling bearings in position axially and transmit axial forces between the component and the groove. DIN 471 applies to shafts, DIN 472 to bores; both standards also specify the associated grooves. The rings are fitted axially: circlip pliers engage in the two holes at the ends. Retaining washers to DIN 6799, by contrast, are pushed radially into the groove of the shaft and enclose the groove base with spring action; they are suitable where no axial access is possible. Their nominal size corresponds to the groove diameter.
The material 1.4122 is a martensitic stainless steel. It is hardenable, magnetisable and wear-resistant, and has good corrosion resistance in environments with a low chloride content; austenitic grades such as A2 and A4 are generally more corrosion-resistant.
Blind rivets and rivet nuts
A blind rivet consists of the rivet sleeve and a mandrel with a predetermined breaking point and is set from one side, particularly in thin-walled sheets and hollow sections. The riveting tool pulls the mandrel back, the mandrel head forms the closing head and presses the components together, then the mandrel breaks off. The clamping range must match the sleeve length; for full strength, the centre of the rivet is at least two sleeve diameters from the edge. ISO 15983 covers open blind rivets with break-pull mandrel and flat head made of A2. Closed-end blind rivets to ISO 16585, also called sealed blind rivets, have a cup-shaped sleeve and are splash-proof on the blind side. Rivet nuts are likewise set from one side and provide a thread in thin components and hollow bodies.
Spring washers and spring cotters
The standards DIN 127 and DIN 7980 for spring washers have been withdrawn. As a safeguard against loosening, spring washers are regarded as ineffective because they cannot compensate for settlement. Spring cotters are standardised in DIN 11024, split pins in ISO 1234.
Parallel keys and set collars
A parallel key sits in the keyway of the shaft, engages in the keyway of the hub and transmits the torque by positive locking, for example to pulleys, gears or couplings. DIN 6885 form A is the tall form with round ends. Set collars to DIN 705 are fixed to the shaft with a grub screw.
Hose clamps DIN 3017
DIN 3017 Part 1 covers hose clamps with worm drive in forms A and B. The material class states what the band, housing and screw are made of: W4 means all parts made of 1.4301 (A2), W5 band and housing made of 1.4401 with screw made of 1.4571 (A4).
