Stainless steel washers
Flat washers to DIN and ISO in normal and large series, washers for timber constructions and for bolts, shim and sealing washers, tab washers, spring, serrated lock and toothed lock washers as well as rosettes in stainless steel. Article number, material and packaging unit are stated for each version.























Standards, materials and dimensions at a glance
Choosing the right washer
Flat washers spread the bearing load of the screw head and nut over a larger area. Selection is made by thread, outside diameter and hardness class. The overview above this text shows which standards, materials and dimensions are in the range.
DIN 125, ISO 7089, ISO 7090 and ISO 7093
The washer DIN 125 is replaced by ISO 7089 (without chamfer) and ISO 7090 (with chamfer), DIN 9021 by ISO 7093 (large series). Function and interchangeability are maintained, even though some dimensions have changed slightly. For the same inside diameter, the large series has a considerably larger outside diameter:
| Thread | Outside diameter ISO 7089 | Outside diameter ISO 7093 |
|---|---|---|
| M8 | 16 mm | 24 mm |
| M10 | 20 mm | 30 mm |
| M12 | 24 mm | 37 mm |
Hardness class 200 HV
ISO 7089, 7090 and 7093 specify the hardness classes 200 HV and 300 HV. For screws and nuts in stainless steel of strength classes 50, 70 and 80, 200 HV is intended, in stainless steel of similar composition. Each additional washer adds another joint interface and therefore settlement losses; use only as many washers as necessary.
Washers for timber and for bolts
DIN 440 covers washers with a square hole, mainly for timber constructions; the round form R is assigned to ISO 7094. Washers for bolts to DIN 1440 are assigned to ISO 8738; some outside diameters and thicknesses have been changed, generally without consequences for interchangeability.
Spring, serrated lock and toothed lock washers
The standards DIN 127 (spring lock washers), DIN 137 (spring washers), DIN 6797 (toothed lock washers) and DIN 6798 (serrated lock washers) have been withdrawn without replacement. As a safeguard against loosening and working loose, these elements are regarded as ineffective in high-strength joints; stainless steel A1 to A5 also lacks the spring-hard properties that could compensate for settlement. More effective are elements with locking teeth or ribs, wedge-locking washers and adhesive locking methods. The tab washers DIN 93 and DIN 463 have likewise been withdrawn without replacement.
Avoiding contact corrosion
If stainless steel meets a less noble metal such as galvanised steel or aluminium in the presence of moisture, the less noble metal is attacked. Insulating washers made of plastic cover the areas at particular risk; they do not separate the connection in the thread.
