Stainless steel nuts
Hexagon nuts to DIN and ISO, lock nuts with clamping element, dome nuts, flange nuts, wing nuts, knurled nuts, eye nuts and square nuts, as well as insert nuts and screw-in nuts in stainless steel. Article number, material and packaging unit are shown for each version.
























Standards, materials and dimensions at a glance
Finding the right nut
A nut is chosen according to thread, height, width across flats and function. The overview above this text shows which standards, materials and dimensions are in the range.
DIN 934 and ISO 4032: what has changed
The hexagon nut DIN 934 is being replaced by ISO 4032. For M10, M12, M14 and M22 the width across flats changes, and ISO nuts between M5 and M39 are also taller. The widths across flats compared:
| Thread | Width across flats DIN | Width across flats ISO |
|---|---|---|
| M10 | 17 mm | 16 mm |
| M12 | 19 mm | 18 mm |
| M14 | 22 mm | 21 mm |
| M22 | 32 mm | 34 mm |
The height of a DIN 934 nut is around 0.8 times the thread diameter; for ISO 4032 in the range M5 to M39 it is 0.84 to 0.93 times. For M12, for example, that is a maximum of 10 mm according to DIN compared with a maximum of 10.8 mm according to ISO. Thin nuts according to DIN 439 are being replaced by ISO 4035; here only the width across flats changes for M10, M12, M14 and M22.
Strength of stainless steel nuts
The properties of nuts made of stainless steel are covered by ISO 3506 Part 2; the nuts are intended to be paired with bolts according to ISO 3506 Part 1. Full-height nuts carry the same property classes 50, 70 and 80 as the bolts. Thin nuts carry the classes 025, 035 and 040 and have a lower load capacity. To prevent seizing, it helps if the nut is one strength class below the bolt.
Lock nuts with clamping element
Nuts with a polyamide ring according to DIN 985 (thin, successor ISO 10511) and DIN 982 (tall, successor ISO 7040) are devices that prevent the nut from being lost. They do not prevent self-loosening, but they hold the joint together after a loss of preload. For the polyamide ring, manufacturers state an operating range of minus 50 to plus 120 °C and single use only, because the ring deforms when the nut is screwed on. Stainless steel nuts with a clamping element can seize when being screwed on; a friction-reducing agent on the thread helps.
Positive-locking elements with locking teeth or ribs directly under the nut and bolt head, as well as wedge-locking washers and adhesive locking, are regarded as effective protection against loosening.
Special types
Dome nuts according to DIN 1587, DIN 917 and DIN 986 cover the thread end. Castle nuts according to DIN 935 are used with a split pin. Eye nuts according to DIN 582 have an eye, while wing nuts and knurled nuts are tightened by hand.
