Hinges
In this category you will find hinges in stainless steel A2 and A4 for hatches, doors, lids and flaps on board and in furniture: flat hinges in many shapes, stamped or as polished precision castings, hinges with cover, automatic hold function or thread, 180-degree hinges, piano hinges, two-part door hinges and weld-on hinges.
























Choosing and fitting the right hinge
Overview of designs
- Flat hinges: rectangular, oval, round, semicircular or trapezoidal, as T-hinge, table hinge or heavy-duty version; trapezoidal hinges with an offset are intended for a difference in level.
- Hinges with three leaves: in A2 or A4.
- Hinges with snap-on cover: according to the manufacturer, you open the cover with a flat-blade screwdriver; further hinges with cover are also available.
- Hinges with automatic hold function: for most versions the manufacturer specifies a constant torque over the entire range of movement.
- Hinges with M6 thread: almost all sizes are also available without thread; the thread length is given for each version.
- Piano hinges: drilled or undrilled, as a full length or per metre, in A2.
- Two-part hinges: also as door hinge, in left-hand and right-hand versions; the separable engine hood hinge has a removable pin.
- Weld-on hinges: in A2, two-part or three-part, some with removable pin.
Selecting size and design
Pay attention to length, width and pin diameter so that the hinge suits the load and the installation situation. With a piano hinge, also called a continuous hinge, a continuous pin connects the leaves; the hinge distributes the load evenly over its entire length and is therefore recommended for large doors, long cabinets and heavy panels. As the piano hinges are made of A2, they belong in dry interior spaces. Hinges with a removable pin make it easier to quickly take off doors and panels.
Sizing the automatic hold function correctly
A flap generates a moment at the hinge: weight force in newtons times the distance of the centre of gravity from the pivot axis in metres. The weight force is the mass in kilograms times 9.81. With a uniform panel, the centre of gravity lies at half the depth; the moment is greatest when the flap is horizontal. The sum of the minimum torques of all hinges, that is nominal value minus tolerance, must exceed this moment; torque and tolerance in Nm are given for each version. This applies if the hinges sit on one axis and carry the load evenly. Too much torque makes the flap stiff to operate, and thin sheets may need reinforcement. Keep the mechanism clean so that it works reliably.
Welding on and installation
After welding on, remove heat tint by brushing, grinding, blasting or pickling, as it promotes pitting corrosion. For screw fixing, use screws of the same grade as the hinge. You will find fasteners under hasps and toggle latches; for the basics on the grades, see the guide V2A, V4A or duplex on a boat.
