Handles & Handrails
In this category you will find flush handles and floor hatch lifters that sit flat in hatches and cabinet doors, round or rectangular, with and without lock and in some cases stated as waterproof. Also available are flat handles, hand grips with holes or thread, chest handles, cabinet door and drawer knobs, and push-button furniture locks, mostly made of stainless steel A4.









Choosing and installing flush handles and hand grips
Flush handles
Flush handles sit flat in hatches and cabinet doors and do not protrude; thanks to the low profile, you are less likely to catch on them when moving about. Many flush handles also serve as a catch: they are available with a spring catch and strike plate or counter plate, and with a lock for securing. With one of the flush handles with lock, according to the manufacturer, pressing the button opens it and pressing the handle makes it engage again. Several flush handles are stated as waterproof, also with compression; individual versions are expressly intended for sealed hatches. On some, the installation depth is adjustable.
Hand grips, chest handle and knobs
Hand grips are available flat, with holes for screw fastening, with internal thread and with thread; according to the manufacturer, some are made of solid cast metal with finger recesses. The chest handle is based on DIN 3136; the standard, which has since been withdrawn, describes surface-mounted box handles with a rounded base plate. Cabinet door and drawer knobs are available ground or polished, with a hole or with thread; choose the finish to match the other fittings. The push-button furniture lock has a plastic housing and a knob made of chrome-plated brass.
Installation and replacement
Before buying, check the cut-out size, door thickness and clearance behind the door; for the push-button furniture lock, for example, the suitable door thickness range is stated with the version. If you are replacing old handles, choose a model that can continue to use the existing holes where possible. Mark the cut-out accurately, test-fit the fitting and seal the screw holes. Where possible, fasten handles right through and, under heavy load, place a backing plate on the rear side to spread the load. They are not stated as grab handles for securing people.
Material
On deck and in the cockpit, use handles made of A4; the versions made of A2 belong in dry interiors. The differences are explained in the guide V2A, V4A or duplex on boats. Matching bolts and cabinet catches can be found under Accessories.
