Tubes & Fittings
Here you will find bendable, polished stainless steel tube in A2 and A4L, as lengths or sold by the metre, plus tube end caps, tube centre pieces, tube extensions and tube end pieces, as well as fittings for bimini, sprayhood and canopy: ball-head joints, deck hinges, canopy fittings with folding-nose pins, bimini tensioners and replacement pins.
























Tubes and tube fittings for bimini, sprayhood and frames
Matching tube and fitting
Tube fittings state the tube diameter they are made for, and some also state the wall thickness, for example 22 x 1.5 mm. For the quick-release tube coupling, the manufacturer states that the diameter given applies to tubes with a wall thickness of 1.5 mm. The stainless steel tube is welded, polished and bendable, and the diameter and length are given for each version. A4L designates the material 1.4404. For frames near salt water, choose A4L, because A2 can show surface rust and pitting corrosion in salt water and salt-laden air. The diameters in which A4L is available are given for each version.
End caps, centre pieces and extensions
Tube end caps are available plain, reinforced, with two screws, with tab, with fork head and with ball-head joint. Centre pieces are available plain, two-piece, reinforced, with two screws and with side mounting. On the tube extension, the threaded adjustment piece is captive, according to the manufacturer.
Ball-head system and canopy fittings
Tube end caps with ball-head joint have a ball with a diameter of 14 mm. The matching ball-head holders, tube centre pieces and canopy fittings take this ball, flat or concave and with D-ring for port or starboard. The plastic insert is available as a spare part. Replacement folding-nose pins are available for canopy fittings with folding-nose pins. With the pin with retaining lanyard, the lanyard keeps the pin captive on the fitting. Bimini tensioners, bimini hinges with quick-release pin, deck hinges with fork head and bimini ball joints for tube or deck mounting keep frame and canopy movably attached to the boat.
Fitting deck hinges
Align deck hinges parallel to the edge of the deck and measure the position on the second side from the stern. On GRP, masking tape under the fitting protects against cracks when drilling. Before drilling, check whether cables or lines run beneath the spot, and apply sealant under the hinge and screw heads. You will find the handrail for the sprayhood frame under Handles and handrails, and canopy and boat covers under Bimini and boat covers.
