Blocks & Accessories
Blocks for redirecting lines: rope blocks and double blocks in stainless steel A2 with swivel eye, joint, becket or swivel snap hook, mini blocks with plain bearing, a folding block and blocks from Wichard. Also cam cleats, angled bases, fairleads, swivel bases, snatch blocks and fittings for Laser dinghies from Allen, the Gyb’Easy boom brake and a line pre-threader from Wichard, a stopper from Spinlock and genoa cars.





















Choosing blocks and cam cleats correctly
The load on the block
Blocks redirect lines and reduce friction. The load on the block depends on the angle of deflection. Wichard states a load factor of 75% at 45°, 100% at 60°, 140% at 90°, 180% at 120° and 200% at 180° of the pull in the line: a pull of 100 kg on a line redirected through 180° results in 200 kg on the block. Compare this value with the breaking load, which is given for each version where the manufacturer states it, and with the fitting from which the block hangs.
Bearings, rope and material
In its selection guide, Wichard assigns its plain bearing blocks to uses such as the halyard, the boom vang, the backstay and the cunningham, and its ball bearing blocks to the mainsheet, the traveller and the spinnaker sheet. Wichard designs its blocks by sheave diameter for specific rope diameters; you will find the matching diameter for each version where stated. The rope blocks are made of A2; where A2 is suitable on board is explained in the guide V2A, V4A or Duplex on the boat.
Cam cleats and accessories from Allen
- Fairleads guide the line into the cam cleat at a favourable angle. Allen recommends fairleads made of aluminium for faster-running and more heavily loaded lines, and those made of plastic for lighter loads and thinner lines.
- Angled bases made of acetal set the cleat at an angle so that the line runs cleanly into the jaws; this reduces friction and wear and improves grip.
- The Pro-Lead guide keeps the line centred in the cleat, even when it is pulled at an angle. A lead bar below the cleat guides in a line that arrives higher up or offset to the side.
- Swivel bases turn the cleat with the line, so that you can operate it from almost any direction. Allen recommends ball bearings for low friction and plain bearings for higher loads.
You will find the fitting for the block under Eye bolts, screws and nuts, and cleats for making fast under Cleats and bollards.
