Fittings & Clamps


















For pipework on board, this category offers fittings with inch threads made of stainless steel A4 and brass, skin fittings, drain outlets, ball valves, hose connectors and quick couplings, plus swing-bolt clamps, retaining clamps and pipe clamps. The subcategories also include hose clips and hoses for drinking water, hot water and tank filling.
Pipework on board: fitting, hose and clamp as a system
The subcategories at a glance
- Fittings: threaded fittings, skin fittings, drain outlets, ball valves, hose connectors and quick couplings made of stainless steel A4, brass and nylon.
- Clamps: hose clips in material classes W4 and W5, swing-bolt clamps, retaining clamps to DIN 3016 and pipe clamps.
- Hoses: drinking water hoses, hot water hose and fuel filler hose for diesel, biodiesel and unleaded petrol, sold by the metre. Pressure and temperature range are stated for each version.
Threads: inch size is not the outside diameter
The inch size of fittings does not refer to an outside diameter but to the bore. A Whitworth pipe thread G 1/2, for example, measures around 20.96 mm on the outside. Before installation, check whether the fitting and its counterpart have a parallel or a tapered thread, and combine only identical thread forms. More on this under Fittings.
Choosing the right hose and clip
Hose connectors state the inside diameter of the matching hose. Hose clips should be made entirely of stainless steel. We supply them in material classes W4 made of 1.4301 (A2) and W5 made of A4. Near salt water, choose W5. On exhaust lines and fuel filler hoses, the American ABYC standard requires double clips. Never position clips beyond the end of the hose tail.
Material and waterline
Brass is an alloy of copper and zinc. Ordinary brass can dezincify: the zinc dissolves out and leaves behind a porous, weak copper structure. Fittings are affected in seawater, but also in soft fresh water. A pink sheen on the fitting is a sign of this. Dezincification-resistant brass is generally marked CR or DZR; our brass fittings are not designated as dezincification-resistant. Ordinary brass is unsuitable for seawater lines. Use skin fittings and drain outlets made of brass only where they remain above water even when the boat heels, for example in the deck, and check them regularly for pink discolouration. Under the American ABYC standard, every skin fitting below the waterline when heeled requires a seacock. Only outlets that are above water at rest may instead be connected with reinforced hose. Stainless steel is not widely used for seacocks because of cost and corrosion problems. Check skin fittings and seacocks regularly, including those made of A4.



