Wire rope clamps
Wire rope clamps in A4 stainless steel and duplex stainless steel for detachable loops, swage clamps in stainless steel, copper and aluminium for permanent connections, cross clamps for rope nets as well as clamping rings, stopper clamps and ball stopper clamps as a stop on the rope. Also available are wire rope clamps with eye and a wire rope cleat.






















Which clamp for which connection
Detachable screw type or permanent swaged type
Wire rope clamps secure rope loops with or without a thimble, can be fitted on site and released again. Swage clamps are pressed with a swaging tool and form a fixed loop that cannot be opened again. The simplex clamp clamps two rope strands with one screw and is small and light. The duplex clamp places the strands side by side and clamps them with two screws. The oval clamp connects two rope strands, for example at the end of a loop.
The Duplex wire rope clamp (two-screw design) is made of A4. The wire rope clamp Duplex is a clamp made of duplex stainless steel. Simplex and duplex clamps do not reach the slip resistance of a U-bolt wire rope grip, and the simplex clamp holds even less than the duplex clamp. Specialist dealers advise against using either in safety-relevant areas, and duplex clamps only for light applications. The load capacity of each clamp is given in the Technical data tab.
Swage clamps to suit the rope
A connecting element should be equally noble or nobler than the component; a stainless steel swage clamp therefore suits a stainless steel rope. Aluminium swage clamps are not the right choice for stainless steel ropes: stainless steel and aluminium should not touch each other in a damp environment, and a small aluminium clamp on a stainless steel rope is worn away particularly heavily by contact corrosion. For its own sleeve system, Nicopress recommends tinned copper or stainless steel sleeves on stainless steel ropes. For the copper swage clamps, the nominal size of the clamp is given in addition to the rope diameter. Which crimping dies suit which swage clamp and which rope diameter is stated for the crimping dies under Tools for wire ropes; the matching thimble can be found under Thimbles.
Cross clamps, clamping rings and stoppers
Cross clamps connect two crossing ropes, for example in rope nets. The 0 to 90 degree version allows any angle; the variant with M10 internal thread sits on a hanger bolt from Pins, split pins & hanger bolts, the one with blind thread on a threaded pin. Two-piece clamping rings clamp the rope at any point as a stop, and the version with four screws holds higher loads. Stopper clamps and ball stopper clamps serve as a stop or end piece, and wire rope stoppers limit the travel of pulleys, eyes and fittings.
