Tools for wire ropes

Tools for wire ropes

Tools for processing wire ropes: a hydraulic swaging tool in a case with dies for terminals and oval compression clamps, hand swaging tools for compression sleeves in the Nicopress system, also with rope cutter, wire rope cutters, a one-hand rope cutter and a cutter for threaded rods.

Items 1 to 9 of 9
ImageDescriptionItem no.DimensionMaterialUnitPriceDelivery timeBuy
Wire rope cutter up to 5 mmCUT04single23,39 EUR per piece3 to 5 working days
Thread cutter, threaded rod cutter, for M6, length 30"GS-06Thread M6, Length 30"single129,99 EUR per piece3 to 5 working days
Hydraulic crimping tool 7t, 480 mm, in plastic case, steel8146781012Length 480 mmStahlsingle290,71 EUR per piece3 to 5 working days
Crimping jaws for terminals, steel6 versionsfrom 203,50 EUR per piece3 to 5 working daysAll versions
Crimping jaws for oval crimp clamps, steel5 versionsfrom 226,06 EUR per piece3 to 5 working daysAll versions
Wire rope cutter, steel5 versionsfrom 41,43 EUR per piece3 to 5 working daysAll versions
Swaging tool 18" for Nicopress C, G, M, X (oval)SWT-18single59,99 EUR per piece3 to 5 working days
Swaging tool 8" Mini, 1.0 to 2.0 mmSWT-08single9,99 EUR per piece3 to 5 working days
Swaging tool for Nicopress C, G, M, P, X, + wire rope cutterNICOZ700single136,99 EUR per piece3 to 5 working days

Cutting and swaging wire ropes cleanly

Cutting without fraying

Wire rope cutters cut stainless steel wire ropes cleanly without fraying the rope. With unsuitable tools the ends fray or the rope is crushed and becomes unusable for further processing. Ropes that are not stranded to be low in stress should be bound tightly to the left and right of the cutting point before cutting, otherwise the wire ends spring open; for other ropes, strong adhesive tape around the cutting point is enough. How far a cutter can cut depends on the construction: with the one-hand rope cutter, the maximum diameter for stiff 1x19 is smaller than for flexible 7x19. The limits are given for each version.

Swaging with a system

The hydraulic swaging tool swages terminals and oval swage sleeves onto wire ropes. The dies for terminals are designated by rope and terminal diameter, those for oval compression clamps by rope diameter; always choose the die that matches your terminal or clamp. A swaged connection cannot be reopened. Matching Terminals and compression clamps can be found in the neighbouring categories.

Hand swaging tools for compression sleeves

The hand swaging tools carry the groove designations of the Nicopress sleeves, such as C, G, M, P and X. In the Nicopress system, each sleeve has a specific groove on the tool and a defined number of presses; the assignment is given in the system's instructions. Nicopress states that each finished press should be checked with a gauge and a proof load applied if there is a risk to persons or property. One tool combines swaging pliers and rope cutter, and the mini tool is designed for thin ropes; the designation states the range in each case.

Shortening threaded rods

The threaded rod cutter cuts threaded rods without damaging the thread at the cutting point; in some cases you will need to do some finishing work after cutting. You will find the matching rope under Wire ropes.