Tenax & locking fasteners
Tenax locking fasteners for boat covers and protective covers: top parts with large cap or with ring in nickel-plated brass, chrome-plated brass or stainless steel A2, fabric bottom parts, bottom parts for screwing and gluing, self-tapping screws and metric screws, installation keys, and A2 screws for further snap fastener bottom parts.











Installing and operating Tenax correctly
How the locking fastener works
Tenax buttons are locking fasteners: the button engages on the bottom part and is released only by lifting; with the ring top part, the ring makes release easier. For the top parts with large cap, Tenax describes the fastener as a snap fastener with self-locking release that cannot be separated without operating the locking catch. To close, grip the top part on the outside at the ring with the larger diameter and press it on; to release, pull on the grip cap. Do not press on the grip cap when closing.
Fitting the top part in fabric
For the top parts with large cap, Tenax specifies a 10 mm hole in the fabric, with a tolerance of plus 1 mm, and at least 10 mm from the centre of the hole to the seam. For the fixing washer of these top parts, Tenax specifies a tightening torque of 2.5 Nm. The clamping range, that is, the material thickness the top part accommodates, is given with each version; for thicker fabrics, there are top parts with a larger clamping range. For the top part with ring, the dimensions given with the version apply.
Choosing the bottom part
- In fabric: for the fabric bottom part, Tenax describes the installation as follows: punch the fabric, unscrew the serrated washer from the bottom part, insert the bottom part with the threaded stud into the fabric from below, screw the washer on loosely from above, hold the fabric in place and tighten the bottom part from below with the key.
- On sheet metal or GRP: bottom part with 4.2 self-tapping screw in A2. For the 4.2 self-tapping screw in a sheet metal nut, Tenax specifies 3.5 Nm.
- In a thread: metric screw M5 in A2, chrome-plated brass or nickel-plated brass.
- On smooth surfaces: bottom part with round plate in stainless steel for gluing or screwing, or the bottom part for screwing with oval countersunk head self-tapping screws to DIN 7983 or ISO 14587. The dimensions are given with each version.
Tools
You tighten top and bottom parts with a key: with the flat sheet steel key with width across flats 9 or the key with wooden handle. You will find plastic fasteners under Minax, marking pins under Marking pins.
