Stainless Steel Plugs, Caps, End Caps

Stainless Steel Plugs, Caps, End Caps

Plugs and end caps made of stainless steel close off open tube ends neatly. Turned from solid material, flat, domed or half-round, with knurl or lamella, also with M8 thread or through hole.

Closing tube ends with plugs: shapes, hold, installation

An open tube end looks unfinished, collects dust and has a sharp edge. A plug is driven into the tube and closes it permanently. Our plugs are turned from solid material, and the surface is finely turned.

Head shapes

  • flat: flush, calm finish, very modern
  • domed: slightly rounded, pleasant on handrails and in passageways
  • half-round: clearly domed, emphasises the tube end and is particularly pleasant to grip

Knurl or lamella

The shank holds the plug in the tube. A knurl (fine fluting) presses into the inner wall of the tube when driven in. A lamella is spring-loaded and holds by clamping force. Both hold without adhesive; for handrails outdoors, a drop of adhesive can provide additional sealing.

Special versions

  • M8 thread: for screwing on a ball, a hook or a threaded rod
  • Through hole 12 or 12.2 mm: for rods, ropes or cables that are routed through the tube end

Fit

Plugs are matched to the outside diameter and wall thickness, for example 33.7 × 2 mm. There are separate plugs for tubes of 16 × 1 mm. Check the wall thickness of existing tubes: a plug for a 2 mm wall sits too loosely in a tube with a 1.5 mm wall.

Driving in without scratches

Position the plug straight, place a piece of wood or a folded cloth on top and drive it in with a rubber mallet. A steel hammer directly on the stainless steel leaves marks. For tubes that you have cut to length yourself, deburr the inner edge beforehand.