Eye Bolts, Screws & Nuts

Eye Bolts, Screws & Nuts

Fixing points for bolting down: eye bolts with metric or wood thread, U-bolts and triangle bolts with backing plates, ring bolts and ring nuts to and similar to DIN 580 and DIN 582, eye screws, screw hooks and spiral hooks, swing bolts DIN 444, long eye nuts, bow nuts and wing nuts, eye bolts and a ring nut from Wichard, a swivelling ring bolt of grade 6, as well as screws to ISO 14585 and ISO 14586, both made of duplex.

Fitting eye bolts and ring bolts safely

Wood thread or through-bolt fitting

Eye bolts and U-bolts are bolted through the deck and provide a secure fixing point on deck. Eyes and eye bolts with wood thread are screwed directly into wood. For heavily loaded fittings, through-bolt fitting is recommended: bolts rather than screws, stainless steel washers under the nuts and a backing plate below deck to reinforce the surface. The U-bolts and triangle bolts are available with backing plates for this purpose.

Ring bolts and ring nuts to standard

Ring bolts to DIN 580 are classed as load-handling attachments under the Machinery Directive and must therefore bear the CE marking; the standard additionally requires an arrow in the axial direction. For lifting, use only ring bolts with these markings; before lifting, check on the part itself that it bears the CE marking and the arrow. The stated load capacity applies only in the axial direction and only if the ring bolt is screwed in fully with sufficient thread depth and sits flat and across its whole surface. With through holes, a nut must be fitted from the opposite side. Side loading should not be applied. Check ring bolts before use for a secure fit and for visible damage such as corrosion or deformation; deformed ring bolts should not be used any further.

Ring nuts to DIN 582 made of steel and stainless steel can be used as part of lifting slings or as fixed anchor points on machines; as mobile load-handling attachments they require CE marking in the EU.

The cast versions similar to DIN 580 and similar to DIN 582 are not ring bolts and ring nuts to standard; do not use them for lifting loads. Wichard points out that cast metal parts are less strong than forged ones of the same design. Their breaking load, where stated, is given for each version.

Keeping stainless steel threads free-running

Fasteners made of austenitic stainless steel such as A2 and A4 behave differently during fitting from hardened and tempered steel screws; if fitted incorrectly, they can cold weld and seize. Seizing sometimes occurs with nuts with a clamping insert. A friction-reducing agent on the bolt thread generally helps, for example with the eye bolts with self-locking nut.

Matching blocks can be found under Blocks and accessories, cleats under Cleats and bollards.