Fittings
Here you will find threaded fittings in stainless steel A4 and brass: reducers, double nipples, sockets and connectors, 45° and 90° pipe bends, tees and plugs. Also available are hose connectors, skin fittings in A4, nylon and PVC with A4, drains, cockpit drains, ball valves, taps and quick couplings with blanking cap.


Fittings on board: thread, material and installation
Reading the inch size correctly
The inch size on plumbing fittings does not refer to an outside diameter but to the bore. A Whitworth pipe thread G 1/2 measures around 20.96 mm on the outside, G 3/4 around 26.44 mm. Before installation, establish whether the fitting and its counterpart have a parallel or a tapered thread, and combine only identical thread forms. Parallel pipe threads to ISO 228 do not seal in the thread itself but by means of a gasket between two sealing faces.
Brass, stainless steel and the waterline
Brass is an alloy of copper and zinc. Ordinary brass can dezincify: the zinc leaches out and leaves a porous, weak copper structure. Fittings are affected in seawater, but also in soft fresh water. A pink shimmer on the fitting is a sign of this. Dezincification-resistant brass is generally marked CR or DZR; our brass fittings are not designated as dezincification-resistant. You should therefore check brass fittings regularly for this discolouration. Ordinary brass is unsuitable for seawater lines. Use skin fittings and drains in brass only where they remain above water even when the boat is heeled, for example in the deck, and check them regularly for pink discolouration. Under the American ABYC standard, every skin fitting below the waterline when heeled requires a seacock. Only outlets that are above water when the boat is at rest may instead be connected with reinforced hose. Stainless steel is not widely used for seacocks because of cost and corrosion problems. Check skin fittings and seacocks regularly, including those in A4.
Skin fitting, valve and hose connector
Hose connectors state the inside diameter of the matching hose, for example 1/2 inch for 13 mm hose. Ball valves open and close with a quarter turn. The ball valves are designated as line valves, not as seacocks. Skin fittings are available with a thread or hose connector, also at 90°, long for thick hull and deck walls, and with a nylon body and A4 cover. The cockpit drain carries water out of the cockpit; the rosette with rubber valve prevents water from flowing into the cockpit. Quick couplings join hoses without tools; the blanking cap seals an open coupling.
Keeping threads free-running
Stainless steel threads can seize when tightened; a friction-reducing agent helps. Suitable clamps and hoses can be found under Clamps and Hoses.
