Terminals

Terminals

Swage terminals with fork, eye, thread, countersunk, lens or T head, also as mini terminals, assembly and screw terminals, forks, eyes and toggles, eye bolts and hook bolts also in duplex stainless steel, weld-on ends, wood-thread terminals, retaining plates, sleeve nuts, lens-head sleeves, solid balls, bevelled washers, cable feed-throughs, wall brackets and copper sleeves, predominantly in stainless steel A4.

Items 73 to 74 of 74
ImageDescriptionItem no.DimensionMaterialUnitPriceDelivery timeBuy
Round stop sleeves made of pure copper for Nicopress tools, for rope Ø 0.6 to 0.8 mm, BNICO-ST-08Wire rope diameter 0,6 bis 0,8 mmsingle0,35 EUR per piece3 to 5 working days
Terminal with threaded eye for wire rope 2 to 4 mm2 versionsfrom 8,99 EUR per piece3 to 5 working daysAll versions
M6 linksTER2-4LAThread M6A4 / V4Asingle8,99 EUR per piece3 to 5 working days
M6 rechtsTER2-4RAThread M6A4 / V4Asingle8,99 EUR per piece3 to 5 working days

Terminals: swaging, screwing, combining

Swage terminal or assembly terminal

Swage terminals are swaged onto the wire rope. The correct swaging, the suitable tool and the right diameter are decisive. Which rope and terminal diameters dies are available for is given under the dies in Tools for wire ropes. You fit the DIY assembly terminals with fork, eye or thread without a swaging tool; they are suitable for 1x19 and 7x7, among others. Screw terminals with grub screw or internal thread are screwed onto the rope, and the terminal with threaded eye is fitted with hexagon socket screws.

Thread, fork, eye and toggle

Threaded terminals with nut form a threaded connection onto which you screw forks, eyes or toggles with matching right-hand or left-hand thread. A threaded piece with right-hand and left-hand thread connects two threaded parts and tensions when turned. Eye bolts and hook bolts combined with a turnbuckle nut from Turnbuckles & rigging screws make a turnbuckle. Toggles are articulated joints and compensate for angles; joints reduce fatigue in standing rigging. T terminals are hooked into a retaining plate, in which they should sit movably. The forks from Blue Wave have UNF fine thread and only fit parts with the same thread.

For balustrades, wood and walls

Countersunk terminals sit flush in a countersunk hole, while lens head terminals form a flat, domed finish. If the rope runs at an angle through a post, bevelled washers at 35 degrees compensate for the angle; the version with cone accepts countersunk terminals. Cable feed-throughs guide the rope cleanly through posts and holes. Terminals and eyes with wood thread are screwed directly into wood; in hardwood and close to the edge, pre-drill. Weld-on ends are welded to posts or steel components, and combination wall brackets and toggles for wall fixing create an anchor point on the wall.

Oval compression sleeves in galvanised copper and round stop sleeves in copper are intended for Nicopress tools. For its own system, Nicopress recommends bare or galvanised copper sleeves for galvanised steel ropes, and tinned copper or stainless steel sleeves for stainless steel ropes. You will find the matching rope under Wire ropes.