Turnbuckles & Rigging Screws
Turnbuckles with eye or hook, rigging screws with jaw, toggle or terminal, open and closed turnbuckle bodies based on DIN 1480 and DIN 1478, pelican hooks and slip hooks, shroud adjusters, rigging screws with UNF thread from Blue Wave and babystay tensioners from Wichard, predominantly made of A4 stainless steel, some made of duplex stainless steel, A2 or chrome-plated bronze.
















Turnbuckle or rigging screw: selection and installation
How tensioning works
In the turnbuckle body, one side holds a threaded piece with a right-hand thread and the other a threaded piece with a left-hand thread. When the centre piece is turned, both ends are drawn together or apart at the same time, without twisting the assembly. Individual turnbuckle bodies combined with eye bolts or hook bolts from Terminals make a turnbuckle. The turnbuckle bodies are available based on DIN 1480 and, in closed tubular form, based on DIN 1478. On the open rigging screw you can see the thread and check the thread engagement depth. The rope tensioners with open body are made of cast A4 stainless steel; on the open rigging screws from Blue Wave, the body is made of chrome-plated bronze and the threaded jaws are made of A4.
Choosing the connection
- Jaw: for pin connections; for the metric jaw tensioners, the pin diameter is stated for each version.
- Eye: tensions between two eyes or shackles.
- Hook: with the hook-to-hook turnbuckle with safety catch, the catch prevents unhooking.
- Toggle: a pivoting joint that compensates for angles. Joints reduce fatigue in standing rigging; if the tensioner has no toggle of its own, for example with jaw-to-jaw or eye-to-eye, specialist rigging retailers recommend an additional toggle at the lower end of the shroud.
- Terminal: the terminal is swaged directly onto the wire rope.
Pelican hooks can be opened under load, slip hooks can be released under load. Shroud adjusters change the length of a shroud in fixed steps. The babystay tensioners from Wichard are available with folding handle, adjusting wheel or ratchet, each with toggle and pelican hook or snap shackle.
Note the thread type
The tensioners and threaded parts from Blue Wave have UNF fine thread in inch sizes, the other tensioners have metric thread; only combine parts with the same thread type and size. For the rope tensioners with open body made of cast stainless steel with eye or hook, the guideline is: thread size at least twice the rope diameter.
Securing and installing
After tensioning, secure the threaded pieces against turning: lock nuts for rigging screws with right-hand and left-hand thread can be found under Pins, split pins & hanger bolts. The jaw-to-jaw rope tensioners made of cast stainless steel have lock nuts on both sides, and their pins are secured with ring cotter pins. For open Blue Wave tensioners there is the Smart Pin: the pin sits in the split pin hole and a hook-and-loop strap holds it to the body. When stainless steel runs against stainless steel, threads can cold weld; a lubricant on the thread helps prevent seizing.
